Peachtree Woodworking Supply 6 Piece Dovetail and Straight Router Bit Set with Brass Setup Bar(not Included)

The Peachtree Dovetail Jig (NOT included and sold separately)comes with a standard router bit set for working with stock from 5/8” in thickness to ¾” in thickness. There are times however, that we would like to make dovetail cuts in different thicknesses of stock. To do this, you will need to use different size router bits to achieve optimum results. Using the wrong size bits can result in damaging the router bit and dovetail jig (dovetail jig NOT included)

• The Peachtree Dovetail Jig (NOT included and sold separately)comes with a standard router bit set for working with stock from 5/8” in thickness to ¾” in thickness. There are times however, that we would like to make dovetail cuts in different thicknesses of stock. To do this, you will need to use different size router bits to achieve optimum results. Using the wrong size bits can result in damaging the router bit and dovetail jig (dovetail jig NOT included)
• This set comes with a Mini Router Bit Set, a Small Router Bit Set and a Box Joint Bit with a Brass Setup Bar. The Mini and Small Router Bit Set both included a straight router bit with a bearing and a dovetail bit with a bearing. The Mini Router Bit Set cuts stock 1/8” thick to 3/8” thick. The Small Router Bit Set cuts stock ¼” thick to ½” thick. The Box Joint Router Bit will cut stock from ½” in thickness to ¾” in thickness.
• The reason we need to use different size bits for different thicknesses of stock is to make sure that dovetail cuts not only look good, but the bearing must sit just right on the Peachtree Dovetail Jig (not included and sold separately) while cutting. Using the incorrect size bit could result in damaging the bit or jig.
• Each router bit included in this set has the set part number printed on the shank. This is done so you can always tell which dovetail bit goes with which straight bit. Each dovetail, straight bit pair of router bits have the same identifying number on the shank. The box joint bit has its own identifying number on it that does not correspond with any of the other bits in the set.
• Also included with this set is a brass setup bar that is machined to exactly 9/16” square. The brass bar is used to for setting up the opposing piece of stock when cutting box joints. It is the exactly width of the box joint bit that is included in this set. This ensures that your box joints will always fit perfectly each and every time! Each bit in this set has a ¼” shank. The bits and the brass bar are stored in the included wooden box with locking clasp.